Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateGarage Door Company in Beverly Hills, CA
Garage door installation in Beverly Hills runs $700 – $2,200 for a new door, with custom and architectural doors often exceeding that range due to the area’s distinctive housing stock. Unlike most cities, Beverly Hills work is judged on how well a door matches a period façade, not just whether it opens and closes. Whitfield Garage Door Repair has served Beverly Hills since 2012, focusing exclusively on garage doors, openers, and installation across LiftMaster, Genie, Clopay, and more. Call (866) 282-6912 for a free estimate.
Why Beverly Hills Homes Are Different
Beverly Hills garages are rarely standard. The flats south of Santa Monica Boulevard include 90212’s apartments and condos with tuck-under and shared garages, but the majority of our calls come from the estate neighborhoods of 90210 and 90213: multi-car garages behind gates, on sloped driveways, often housing doors that were custom-built for a specific architectural style. A mid-century modern in Trousdale Estates, a Spanish Revival in the Flats, a contemporary build in Benedict Canyon – each expects a door that belongs to that house. Standard off-the-shelf replacements usually look wrong, so our work leans toward measured, period-correct, and custom-matching repairs rather than generic swaps.
Climate matters too. Dry summers and Santa Ana winds pull moisture from wood panels, causing warp and finish cracking. Winter rain and the marine layer feed rust on tracks, hinges, and springs, especially on hillside properties where drainage runs toward the garage. And those hillside driveways create slope conditions that change torsion requirements and safety setup on every spring or cable job. A door that was perfectly balanced on a flat lot behaves differently on a 15-degree driveway approach. We factor that in before any repair or installation.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Main Beverly Hills Services
Most Beverly Hills homeowners call us for one of two reasons: a door that stopped working or an opener that won’t respond. Both are covered below in detail.
Garage Door Repair in Beverly Hills
A broken spring on a custom carriage door, a bent track on a canyon-edge driveway, dry-rotted wood panels on a 1960s estate: these are typical Beverly Hills repair calls. In 90210 and 90213 especially, parts are often no longer stocked, so we measure, source, or fabricate what the door needs rather than forcing a replacement. The goal is always repair first. If you’re hearing grinding, seeing sag, or the door won’t lift, read our full breakdown at Garage Door Repair in Beverly Hills.
Garage Door Opener Repair in Beverly Hills
Older estates often have original or early-generation openers still wired into the house. We work on LiftMaster, Chamberlain, Genie, and Craftsman units, diagnosing the electronics and mechanical drive rather than swapping parts blindly. Beverly Hills garages also tend to be larger and heavier, so an opener that was underpowered from day one will struggle for years before failing outright. For a detailed discussion of opener diagnostics, circuit board issues, and remote problems, see Garage Door Opener Repair in Beverly Hills.
Garage Door Installation in Beverly Hills
Installing a new garage door in Beverly Hills is rarely a simple swap. Most homes date to the mid-century or earlier, with garage openings sized for custom or oversized doors rather than today’s standard dimensions. Add the Mediterranean climate – dry heat that warps wood, winter rain that rusts hardware – and you get a job where material choice, sealing, and structural fit matter as much as the door itself. Our team handles the full Garage Door Installation process, from measurement and ordering through balanced installation and opener pairing.
What makes Beverly Hills installation different is the standard. On a street-facing estate in 90210, the garage door is part of the architectural composition. Replacing a period wood door with an aluminum panel would be an obvious downgrade. We match style, weight, and material to the existing home, then install it to operate cleanly on the specific slope and track configuration of your garage.
Garage Door Replacement
Signs you need it
Your door has a cracked or rotted wood panel, severe rust-through on steel, or structural damage that makes repair more expensive than replacement over the door’s remaining life.
What it costs in Beverly Hills
New door installation in Beverly Hills runs $700 – $2,200, with architectural wood, glass, and custom carriage doors at the upper end or beyond depending on specifications.
How we do it
We measure the opening and track, order the correct door for the dimensions and weight, remove the old door carefully to protect surround finishes, install the new panels and hardware, balance the springs for your driveway slope, and pair your opener.
Garage Door Installation Service
Signs you need it
You’re building a new garage, converting a carport, or want a different door style that complements your home’s architecture without touching the existing opener beyond reprogramming.
What it costs in Beverly Hills
Installation service beyond the door itself, including removal of old equipment, track adjustment, and opener pairing, generally sits within the $700 – $2,200 new-door range depending on complexity.
How we do it
We survey the opening, verify clearance and power access, install tracks and panels level and square, set spring tension correctly, and test the full travel cycle with the opener included.
Garage Door Installation Contractors
Signs you need it
Your project involves permits, HOA design review, or coordination with a general contractor and you need a specialist who can spec and install the door to plan.
What it costs in Beverly Hills
Contractor-coordinated installations in Beverly Hills typically fall in the $700 – $2,200 range for the door and labor, excluding any architectural review or custom fabrication fees.
How we do it
We work from architectural drawings or site measurements, order the specified door, handle the structural mounting and balancing, and provide the installation documentation your contractor or city office requires.
Garage Door Seal Installation
Signs you need it
You see daylight under the door, water stains inside the garage after rain, or rodent debris along the base of the door.
What it costs in Beverly Hills
Seal and weatherstrip installation falls within the broader garage door repair range of $150 – $600, with most bottom-seal replacements toward the lower end.
How we do it
We remove the old seal, clean the channel, cut and fit the new bottom seal or perimeter weatherstrip to your exact door width, and test the closed position for a full-contact seal against the floor.
What Garage Door Installation Costs in Beverly Hills
| Item | Typical range in Beverly Hills |
|---|---|
| New Door Installation | $700 – $2,200 |
| Opener Installation | $250 – $550 |
| Panel Replacement | $250 – $500 |
Do you install custom and architectural doors in Beverly Hills?
Yes. We measure for custom wood, glass, and carriage-style doors and install them to balance correctly on sloped driveways. Call (866) 282-6912 to discuss your specific opening dimensions and door style.
How long does an installation take in Beverly Hills?
Most standard installations finish in one day. Custom doors with long lead times may require two visits: one for measurement and frame work, one for final your door and balancing. We quote the timeline before work starts.
Brands We Service in Beverly Hills
We stock parts for LiftMaster, Chamberlain, Genie, and Clopay, with access to Wayne Dalton, Amarr, Craftsman, and Raynor distribution channels when a Beverly Hills job calls for it. See our brands for the full compatibility list. Most common parts arrive same week; we quote turnaround on the phone before any work is scheduled.
See the difference
Before
After
Before
After
Before
AfterPricing for Garage Door Company in Beverly Hills, CA
| Service | Typical range in Beverly Hills |
|---|---|
| Garage Door Repair | $150 – $600 |
| Spring Repair | $180 – $340 |
| Cable Repair | $130 – $250 |
| Opener Repair | $120 – $320 |
| Opener Installation | $250 – $550 |
| Panel Replacement | $250 – $500 |
| Track Realignment | $120 – $240 |
| Roller Replacement | $110 – $220 |
| New Door Installation | $700 – $2,200 |
Beverly Hills pricing moves upward when we’re working on custom doors, hillside properties with sloped driveways, or openings that need architectural matching. The quotes are always fixed before work starts: we agree on the exact price and scope first, and you approve it in writing before a tool comes off the truck.
Neighborhoods We Serve in Beverly Hills
We work across all four Beverly Hills ZIP codes, from the estate sections of 90210 to the condos of 90212. Response time across the city is typically same-day or next-morning for repair calls, with installation scheduled around material lead times.
- Trousdale Estates
- Benedict Canyon
- The Flats
- Beverly Hills Gateway
- Coldwater Canyon
Service Area – Cities Near Beverly Hills
Whitfield Garage Door Repair routes technicians from Lake View Terrace to Beverly Hills and surrounding communities. We also cover the adjacent San Fernando Valley areas, including Lake Balboa, CA, Sun Valley, CA, Panorama City, CA, and North Hills, CA. If your property sits near the Beverly Hills border, call and we’ll confirm coverage.
Serving Beverly Hills, CA – Our Local Coverage Area
We’re based in the Beverly Hills area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Garage Door Company in Beverly Hills
Yes. We cover ZIP codes 90212, 90213, 90209, and 90210, including the estates, flats, and hillside neighborhoods throughout the city. Call (866) 282-6912 to confirm a same-day slot for your repair.
Some Beverly Hills neighborhoods have design review requirements for street-facing doors, and custom or structural work may need city approval. We install to the property’s existing opening and can coordinate with your HOA or architect on specifications.
We schedule standard installations within a few business days of your approval. Custom doors take longer because of manufacturing lead times. We’ll confirm the schedule and final price before any work begins.
What happens when you call
- 1A real person answersNo phone trees. Talk to a local garage door pro.
- 2You get an upfront price rangeHonest numbers before anyone is dispatched. No surprises.
- 3A background-checked tech heads outLicensed & insured, typically the same day.
- 4You approve before work beginsNothing starts until you say go.
What Beverly Hills Customers Say
"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Bethany Vaughn"Fixed the spring properly and the door works fine. He did leave the old spring and some hardware by the side of the house, and I had to text to ask about hauling it off. They came back for it, just took a couple of days."
- Holly Reed"Opener kept reversing halfway down. Turned out to be the safety sensors knocked out of alignment by a bicycle. He straightened them, wouldn't charge me for it, and just asked me to keep them in mind if I need real work later."
- Daniel Whitaker