Full-view glass
Raised-panel steel
Carriage house
Modern flush
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the truck arrives.
Get your free estimateStyles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
See the difference
Before
After
Before
After
Before
AfterHow Much Does Spring Replacement Cost in Lake View Terrace?
Spring replacement in Lake View Terrace typically runs $180 to $340, with most single-spring jobs landing around $240 and two-spring setups closer to $320. Torsion springs (the ones mounted on the shaft above the door) sit at the higher end; extension springs on older doors cost less. That range covers the springs, the labor, and a proper balance test so the door doesn’t chew through the new springs in a season.
If your door won’t lift, you may be looking at a snapped spring, but it could also be a frayed cable, a blown capacitor in the opener, or a door that’s simply off-track. A garage door specialist can tell the difference in a few minutes. We work on LiftMaster, Chamberlain, Genie, Craftsman, and the rest of the major opener and door brands every week, so we diagnose by what’s actually wrong, not by what’s easiest to sell.
Key Takeaways
- Most spring replacements in Lake View Terrace fall between $180 and $340.
- Torsion springs cost more than extension springs; two-spring doors cost more than one-spring doors.
- The springs are the cheap part. The labor, safety, and correct tensioning are what you’re paying for.
- Never try to swap torsion springs yourself. The stored tension can cause serious injury.
- Free estimates from Whitfield Garage Door Repair: (866) 282-6912.
Spring Replacement Cost Breakdown (2026)
Here’s what individual pieces of a spring job look like in the Lake View Terrace market this year. These are real ranges, not teaser numbers. Actual quotes depend on your door’s weight, spring configuration, and how much of the surrounding hardware needs attention.
| Line Item | Typical Cost |
|---|---|
| Single torsion spring replacement (one spring) | $180 – $260 |
| Double torsion spring replacement (pair) | $260 – $340 |
| Extension spring replacement (pair, older door) | $180 – $240 |
| Spring plus cable repair (cables often go with springs) | $220 – $340 |
| Cable repair (if needed alongside) | $130 – $250 |
| Roller replacement (when the door is already apart) | $110 – $220 |
| Track realignment (if the door jumped or twisted) | $120 – $240 |
| Opener repair (if the opener was strained by the broken spring) | $120 – $320 |
| Full garage door repair (broader fix) | $150 – $600 |
What drives cost up: a two-spring door where both springs are tired, a door that’s been run on a broken spring long enough to warp the panels or crack the end plate, and high-cycle or heavier-gauge springs for oversized doors. What drives cost down: a single-spring standard door, extension springs on an older model, and a job where the cables, rollers, and opener are all healthy. If your door is genuinely beyond repair, we’ll tell you, but we won’t push a new door when a spring swap and a tune-up gets you another decade of use.
What Affects Spring Replacement Pricing in Lake View Terrace
- Spring type. Torsion springs (mounted above the door) cost more to replace than extension springs (mounted alongside the tracks). Torsion is the standard on anything built in the last 30 years, and it’s what we work on most in Lake View Terrace.
- One spring or two. A single-spring door sits at the low end of the range. A two-spring door – which is what you’ll find on most double-wide and heavier doors – needs both springs matched, so the labor and parts push toward the top of the range.
- Door weight and size. A 16-foot double door with insulated panels weighs a lot more than a single door. Heavier doors need heavier-gauge springs, which cost more and take longer to tension correctly.
- Condition of surrounding hardware. Springs rarely fail in isolation. If the cables are frayed, the rollers are flat, or the end plates are cracked, that gets added to the ticket. We quote it all upfront so there are no surprises.
- Access and clearance. A garage with a low ceiling or tight clearance in a Lake View Terrace hillside home takes more time and sometimes needs different springs than a standard-height door.
- Whether the door has been run on a broken spring. Many homeowners in this area keep using the opener for a few days after a spring snaps. That strains the opener motor, bends the door panels, and can crack the end plate. The sooner you call, the cheaper the fix.
How to Save on Spring Replacement
The single biggest cost saving is timing. Call as soon as a spring snaps or the door starts lifting crooked. Running the door on a broken spring is how a $240 spring job turns into a $600 repair that includes cable, roller, and opener work. In neighborhoods like Pacoima, Sunland, and Shadow Hills, we regularly see doors that sat on a broken spring for two or three weeks before anyone called – and those jobs cost more.
A few practical ways to keep the price down:
- Get a quote before the door is dismantled. A free estimate from us means you’re comparing numbers, not guessing. Call (866) 282-6912 and we’ll give you a range over the phone based on your door type.
- Ask about both springs. If one spring broke, the other is almost certainly the same age. Replacing both together costs less than replacing them six months apart, because the labor is shared.
- Bundle routine work. If the rollers are worn or the cables are frayed, do them while the door is already apart. A roller replacement at $110 – $220 alongside a spring job is cheaper than two separate visits.
- Don’t skip the opener check. A spring failure can strain the opener motor. A quick diagnostic now ($120 – $320 range for repair, if needed) beats a burned-out motor later.
- Stay on top of lubrication. A little garage door lubricant twice a year won’t fix a broken spring, but it slows wear. We’ll show you where to spray when we’re out.
Free estimates are part of every job. We’ll tell you what’s actually wrong before we touch anything, and we won’t try to sell you a new door when a spring swap will do.
FAQs – Spring Replacement Cost
How much does spring replacement cost in Lake View Terrace, CA?
Spring replacement in Lake View Terrace costs $180 to $340 for most homes, with the average job landing around $240. Single torsion springs sit at the low end; two-spring doors and heavier doors sit at the top. Call (866) 282-6912 for an exact quote – estimates are free.
Is it cheaper to repair or replace a garage door with a broken spring?
Repairing the spring is almost always cheaper. A spring replacement at $180 – $340 is far less than a new door installation at $700 – $2,200. Unless the door panels are warped, the hinges are torn out, or the door is otherwise beyond saving, we recommend repair first. We’ll tell you honestly if a new door is the better spend.
Can you come out today?
In most cases, yes. Broken springs are the most common call we get, and we do our best to get out the same day. Call (866) 282-6912 and we’ll tell you the soonest available window for your address in Lake View Terrace or the surrounding hillside neighborhoods.
Why did my spring break in the first place?
Springs break for three reasons: age, cycle count, and use. A standard torsion spring is rated for roughly 10,000 cycles. If your door opens and closes four times a day, that’s about seven years. In Lake View Terrace, the dry heat and seasonal temperature swings accelerate the wear, and springs near the top of a hot garage tend to fail around the eight-year mark rather than ten. High-cycle springs cost a bit more upfront but last roughly 25,000 cycles, which is often worth it for households that use the door heavily.
Do you use genuine brand parts?
Yes. We carry parts for the major opener and door brands – LiftMaster, Chamberlain, Genie, Craftsman, Clopay, Amarr, Wayne Dalton, and Raynor – so the springs and hardware we install match your existing equipment. If your door is an off-brand or older model, we’ll source the right gauge and length rather than forcing a generic spring. Call (866) 282-6912 for a parts check before we come out.
How long does the job take?
A typical single-spring replacement takes about an hour from arrival to final balance test. A two-spring door with cable and roller work alongside takes two to three hours. We test the door balance at the end, which is the step most quick-fix outfits skip and the reason their springs fail early.
Why Choose Whitfield Garage Door Repair for Spring Replacement in Lake View Terrace
We’re a garage door specialist, not a general contractor who happens to fix doors. That matters when something fails on your door. Where a handyman might guess at the problem, we know the equipment – the spring gauge, the cable tension, the opener electronics that keep the whole system working. We work on the eight most widely installed garage door and opener brands in the country, and we’ve seen just about every failure pattern they produce. When we walk into a Lake View Terrace garage, we’re not guessing. We’re matching what we see to what we already know.
Three things you get with us:
- Repair-first thinking. We fix what’s broken before we recommend replacement. If a spring swap gets you another ten years, that’s what we’ll quote.
- Brand-agnostic diagnostics. We don’t push parts we happen to have on the truck. We recommend what’s right for your door and your opener, whether that’s a LiftMaster, a Chamberlain, a Genie, or a Craftsman.
- Full-service scope under one name. Spring replacement, opener repair, and full door installation – so you’re not hunting down a second company when your needs change.
If you want the bigger picture on what spring replacement involves before you call, our Spring Replacement in Lake View Terrace guide walks through the process from first inspection to final balance test. You can also see how spring work fits into broader repair pricing on our garage door repair page, and check our opener repair service if the motor has been straining. Homeowners in nearby Pacoima and Sunland call us for the same spring failures. If you’re weighing a new door against a repair, our garage door installation page covers the full cost picture, and our panel replacement page explains what it takes to fix a door that’s been run on a broken spring.
We also handle the smaller jobs that come up alongside a spring failure: cable repair, roller replacement, track realignment, and opener installation if your current motor is on its last legs. If you’re in the San Fernando Valley and not sure whether we cover your block, our Los Angeles page has the broader service map, and our Burbank page covers the nearby market. Everything routes back to one number, and one team that only does garage doors.
Get a Free Spring Replacement Estimate
If your door won’t lift, you’re hearing the spring clank when it moves, or you’ve noticed a gap in the coils above the door, call us. We’ll give you a straight answer about what’s wrong, what it costs, and whether a repair makes sense. Most spring replacements in Lake View Terrace run $180 to $340, and we’ll confirm the price for your door before we start. Call (866) 282-6912 for a free estimate.
Pricing reflects the Lake View Terrace market as of 2026. Whitfield Garage Door Repair offers free estimates – call (866) 282-6912.
What Our Customers Say
"Good repair, reasonable money. The door still has a slight shudder about a foot from the top that he said is the track being slightly out of true on an old frame and would cost real money to fix properly. Fair enough, but I'd hoped it would be perfect."
- Luis Delgado"Track was bent and two of the rollers were shot. He straightened what he could, swapped the rollers for nylon ones, lubricated everything, and had it done in about an hour."
- David Park"Both cables had come off the drum and the door was hanging crooked. I'd watched a video and was about ten minutes from trying it myself, which the tech told me would have been a genuinely bad idea. Glad I called."
- Bethany Vaughn